Five Oceans Adjustable Fishing Rod Holder for Kayak and Boat - Deck Mount Base with Sliding-Lock Mechanism, High-Impact Nylon, Large FO4748 Review (2026)

Who this rod holder is for

This rod holder suits kayak and small boat anglers who want to adjust a rod's angle on the fly, whether trolling with the rod tip low or casting with it more upright, rather than accepting one fixed angle from a flush-mounted holder. The large FO4748 size is built for bigger spinning, baitcaster and fly setups rather than light tackle rods, and the deck mount base means it sits above the deck surface rather than flush with it, which some anglers prefer for quick rod removal. Paddlers with narrow or already cluttered decks should think through placement carefully, since a raised holder takes up more space than a flush mount and can catch a paddle blade or line on a tight cockpit.

How the sliding-lock mount and adjustability work

The holder uses a deck mount base with a sliding-lock mechanism and an interchangeable 12-point mount system, letting the rod holder itself be removed from its base and swapped between different mount points on the kayak without tools. Elevation is adjustable and the holder rotates a full 360 degrees, locking in place every 30 degrees so you can dial in a trolling angle low to the water or a more vertical casting position and have it hold there. A rotating locking collar around the rod grip secures the rod itself once seated, which is meant to prevent it sliding out during a hard strike or while the kayak is moving over chop.

Setting it up and using it on the water

Installation uses four stainless steel screws to fix the deck mount base to the kayak or boat deck, and the rod holder then locks onto that base without further hardware. Once mounted, day to day use means seating the rod, locking the collar, and adjusting the 30 degree increments to match trolling speed or casting style, then removing the whole holder from its base when it is not needed for storage or to reduce deck clutter while paddling through tight spots. Because the holder sits proud of the deck when mounted, it is worth mapping out a spot that keeps it clear of paddle strokes and stepping room before drilling the mounting screws in permanently.

Trade-offs, a build material note and how it compares with named rivals

A source note worth flagging: the Amazon listing describes the material as high-impact nylon, but the manufacturer's own product page lists it as UV-stabilized, fiberglass-reinforced plastic, which is a related but different material claim worth knowing before you buy. Against a flush mount rod holder like the Yak Gear Flush Mount kit or the Brocraft flush deck holder, this raised design is more visible on deck and easier to spot and grab in a hurry, but it protrudes further and is more likely to catch a paddle or line than a flush design sits below deck level. Compared with the Borogo or Pelican flush mount holders, the FO4748's adjustability at 30 degree increments is a genuine advantage for anglers who troll and cast on the same trip.

Verdict: who should buy it and who should skip it

Buy this rod holder if you want the ability to change a rod's angle between trolling and casting without swapping hardware, and you are comfortable placing a raised, removable holder somewhere it will not interfere with paddling. The stainless steel mounting screws and removable design are practical for anglers who like to declutter the deck when not fishing. Skip it if your kayak deck is already tight on space, where a flush mount holder will sit lower and out of the way, and note the material discrepancy between the nylon listed on Amazon and the fiberglass-reinforced plastic named on the manufacturer's own page before you decide.

Frequently asked questions